I modified my lights by removing the single filament fitting and putting a double filament fitting used for the brake/park lights from a couple of old assemblies I had lying around.
Just bend up the tabs to remove and push them down flat again when you instal though I did add a drop of aradite to make sure it would move.
I'm not sure if the fittings from a clubbie will fit,you may need to use the ones from a round nose.

Basic and it works. Also can be used to get revenge on driver following with high beam on. If any one fits a manually operated reverse light it must have an internal warning light for when it is switched on.

_________________
Chris

Everything I like is either
illegal, immoral or fattening.

Or a big spotty...Yer I know its illegal but I was spotted by a truck driver once when he thought I was to close to his arse

_________________
Stop Licking the Dog...I Don't Care Who Started It

Sorry for the delay in getting back.

Thanks to all of the advice, it has been very helpful!

I have a couple of old tail lights with broken indicator plugs, so i think I'll have a play with these first (junk anyways). If I don't have any joy then the 'fog' light on the boot will be my next choice.

Any know the rules for adding one in QLD (max wattage etc)??

Cheers
Matt