ausmini
https://www.ausmini.com/forums/

What did you do on your Mini today?
https://www.ausmini.com/forums/viewtopic.php?f=2&t=52415
Page 1 of 569

Author:  willy [ Wed Apr 22, 2009 11:06 pm ]
Post subject:  What did you do on your Mini today?

Hopefully this will continue onto being a long-running thread.

Stolen from another forum.

Pics are ok - limit them to one or two if you can, and keep them at a usable forum size (800x600).


SO.... What did you do on your Mini today?

Today I bought some new fuel line, new Facet competition fuel pump, and did a small rust replacement on the rear floor (panel that the rear seat cushion sits on).

Author:  BALLISTIC [ Wed Apr 22, 2009 11:15 pm ]
Post subject: 

Nothing on mine........but I made 1 blokes run, stop and steer much, much better! :D Another one had the engine painted red! so it will go 10% faster of course :wink:

Author:  doogie [ Wed Apr 22, 2009 11:16 pm ]
Post subject: 

Graham Russell milled one of his manifolds for me, as im having trouble fitting my HIF44 carb & manifold into my MK2 Cooper S, after getting it milled i refitted it to the car, still no luck, manifold won't seal onto the manifold gasket.

Looks like it gunna have to trim some metal out of the firewall :shock:

Doogie

Author:  superSeven [ Wed Apr 22, 2009 11:19 pm ]
Post subject: 

bought a new water pump.. cast impellor! :D

Author:  red_850 [ Wed Apr 22, 2009 11:26 pm ]
Post subject: 

I reamed out my trailing arm bushes.

Author:  DTrain [ Wed Apr 22, 2009 11:40 pm ]
Post subject: 

havent done anything since the last holidays, and wont be doing anything till the next one. ie june :(

Author:  d1ck0 [ Wed Apr 22, 2009 11:52 pm ]
Post subject: 

I thought about what I need to do to get in going for the Cruise to the Qld Mini Muster. Does that count?

Dicko

Author:  justfanginaround [ Wed Apr 22, 2009 11:54 pm ]
Post subject: 

flogged the crap out of mine coz the new motor is about to be finished

Author:  AEG163job [ Thu Apr 23, 2009 12:29 am ]
Post subject: 

severely reduced the power-to-weight ratio of my Moke- refitted the sump guard.........
in readiness for a Deua National Park adventure. :)

Author:  brett [ Thu Apr 23, 2009 12:42 am ]
Post subject: 

had a new alarm system fitted take that Theives

Author:  MiniMan_Alis [ Thu Apr 23, 2009 7:23 am ]
Post subject: 

i brought parts from the mini king!!!!




with the stimulus package :twisted:

Author:  miniDave [ Thu Apr 23, 2009 7:32 am ]
Post subject: 

- Removed front hubs and greased the bearings
- Painted and replaced the brake backing plates
- Installed new twin wheel cylinders on each side
- Re-shimed the top and bottom ball joints on both sides
- Drilled out a broken grease nipple, re-threaded and replace nipple in hub
- Connected new brake hoses on both sides on the front
- Replaced new brake line that runs around front of the front subframe
- Bolted new engine mounts to engine (ready to put in)

Author:  i got a mini [ Thu Apr 23, 2009 7:36 am ]
Post subject: 

bout to pull out my radiator casue it is no good :( not looking forward to it

Author:  matt van'74 [ Thu Apr 23, 2009 7:50 am ]
Post subject: 

I chased some electrical faults and cleaned up the wiring a bit in spots.

Then took it for a drive.

Matt

Author:  gafmo [ Thu Apr 23, 2009 7:57 am ]
Post subject: 

Yesturday I back to Blinging the 48 Dellorto :roll: why did I start it in the first place :twisted:

Page 1 of 569 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/