Hi all
Still having a few issues with the clubby. Hoping someone might have experienced the same problem and might offer some advice. I'm planning to take it to local mini mechanic for a thorough going over but getting it there is the difficult bit.
History:
Have had some dirty fuel issues recently which ended up blocking the fuel pump so installed a new pump and cleaned out the fuel tank and lines. Now have good flow through filter to carby so thought problem was sorted but, today, we couldn't get the engine to run smoothly on start up at all. We tightened the distributor mounting bolts and adjusted the points which smoothed it right out. Once on the road, however, the mini began to hesitate after about 5 or so seconds then just cut out completely. It would restart but then the same thing happened - kangaroo hopping down the street is not a good look
This is what what has been done in the past few weeks:
New mechanical fuel pump.
Cleaned fuel tank
Replaced fuel hoses
Replaced fuel filter (before carby)
New leads
New spark plugs
Checked fuel vent pipe
Checked fuel pipe
Installed electronic ignition but then stuffed it up when trying to wire up tacho (back to points now)
Any help on what I could check or replace would be greatly appreciated.
Thanks
Eiles