ausmini
http://www.ausmini.com/forums/

Drive flange offsets- 7.5" to 8.4"
http://www.ausmini.com/forums/viewtopic.php?f=2&t=96143
Page 1 of 1

Author:  Harley [ Thu Oct 12, 2017 10:14 am ]
Post subject:  Drive flange offsets- 7.5" to 8.4"

Hopefully a quick one for those that know / have a flange of each to compare:
Is the drive flange of an 8.4" brake setup the same in offset from bearing to wheel mounting face as it is on a 7.5" setup? Was looking at some photos recently and it looks different but i can't quite tell.
Thanks!
:D

Author:  peterb [ Thu Oct 12, 2017 4:12 pm ]
Post subject:  Re: Drive flange offsets- 7.5" to 8.4"

they mount differently, one with the wheel studs, the other has own bolts.........if that makes sense

Author:  Harley [ Thu Oct 12, 2017 8:38 pm ]
Post subject:  Re: Drive flange offsets- 7.5" to 8.4"

Hi Peter, I'm trying to work out of changing from one setup to the other will alter the front track dimension?

Author:  peterb [ Fri Oct 13, 2017 6:00 am ]
Post subject:  Re: Drive flange offsets- 7.5" to 8.4"

I don't think it does, I swapped mine 8-7 and didn't notice any change. Didn't actually put tape over it but looking at tyre/guard position I'd say the same.

Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/