ausmini https://www.ausmini.com/forums/ |
|
Rear Mini Wiring Loom https://www.ausmini.com/forums/viewtopic.php?f=2&t=96259 |
Page 1 of 1 |
Author: | cooperess [ Thu Nov 02, 2017 2:50 pm ] |
Post subject: | Rear Mini Wiring Loom |
Whilst pulling my Cooper apart I found AYA9196 on the rear wiring loom. When was this loom used (from date to finish date) and what models? |
Author: | cooperess [ Thu Nov 02, 2017 3:07 pm ] |
Post subject: | Re: Rear Mini Wiring Loom |
Attachment: Mini Rear Wiring Loom Old 003.jpg Here is a Picture
|
Author: | winabbey [ Thu Nov 02, 2017 4:39 pm ] |
Post subject: | Re: Rear Mini Wiring Loom |
Looks like that body harness was used for the MK II Mini series beginning in 1969. No information on whether it was superceded before the end of round-nose production but I suspect not. Reversing lights weren't introduced until the Clubman series, except the SPO41 harness to enable reversing lights. On the following page, S is for Saloon and V for Van. Attachment: PUB1012 N30-1 R.jpg
|
Author: | winabbey [ Thu Nov 02, 2017 4:44 pm ] |
Post subject: | Re: Rear Mini Wiring Loom |
The parts books show that loom as also being used in the early non-GT Clubman production. Attachment: PUB1052 pN16.jpg
|
Author: | cooperess [ Sat Nov 11, 2017 8:52 am ] |
Post subject: | Re: Rear Mini Wiring Loom |
Thanks winabbey. Do you have the illustrations referred to on the picture, if so, I am interested in seeing the Item illustration No.s 1B & 2D Quote: On the following page, S is for Saloon and V for Van.
Attachment: PUB1012 N30-1 R.jpg |
Author: | Mick [ Sat Nov 11, 2017 9:28 am ] |
Post subject: | Re: Rear Mini Wiring Loom |
There is a difference between the Mini K rear wiring loom and the Cooper S, in that there is a need for a switched 12 volt wire to run to the rear mounted electric fuel pump. This is a white wire running in the middle pin if I remember correctly. Otherwise it is left empty. |
Author: | winabbey [ Sat Nov 11, 2017 10:56 am ] |
Post subject: | Re: Rear Mini Wiring Loom |
cooperess wrote: Thanks winabbey. Do you have the illustrations referred to on the picture, if so, I am interested in seeing the Item illustration No.s 1B & 2D The illustration page in the parts book just shows the routing of the harnesses, not the cable lengths, wiring colours and terminations that I suspect you are wanting? This information is in the workshop manual. Below are the relevant pages from the most comprehensive BMC produced workshop manual, TP832, the black covered publication. Attachment: PUB1012 N30 L.jpg Attachment: TP832C p n-20.jpg Attachment: TP832C p n-21.jpg Mick wrote: There is a difference between the Mini K rear wiring loom and the Cooper S, in that there is a need for a switched 12 volt wire to run to the rear mounted electric fuel pump. This is a white wire running in the middle pin if I remember correctly. Otherwise it is left empty. I have a feeling the same loom was used but the fuel pump wire just taped up out of the way on the Mini K. I wonder if a Mini K owner could check their car and report back? |
Author: | Mick [ Sat Nov 11, 2017 11:11 am ] |
Post subject: | Re: Rear Mini Wiring Loom |
The Mini K looms I have had had the center wire not fitted, but certainly may not be across the board. I would suppose they would share a part number if they were used on either model? |
Author: | Stibbsy [ Sat Nov 11, 2017 12:22 pm ] |
Post subject: | Re: Rear Mini Wiring Loom |
The rear wiring loom on my '69 Mk2 'S' has a white wire Attachment: image.jpeg
|
Author: | simon k [ Sat Nov 11, 2017 12:56 pm ] |
Post subject: | Re: Rear Mini Wiring Loom |
Stibbsy wrote: The rear wiring loom on my '69 Mk2 'S' has a white wire Attachment: image.jpeg which pin does it go to? cooperess' loom appears to have a white wire, but doesn't go to the centre |
Author: | Stibbsy [ Sat Nov 11, 2017 1:28 pm ] |
Post subject: | Re: Rear Mini Wiring Loom |
Simon, The white wire is on the ribbed edge of the block in the middle between purple wire and green with red trace. It's defineatly for the fuel pump. |
Author: | drmini in aust [ Sat Nov 11, 2017 2:48 pm ] |
Post subject: | Re: Rear Mini Wiring Loom |
My 70 Matic has no white wire, the pin is vacant. Ditto the loom in my son's 71 Clubby. |
Author: | Tim I [ Thu Dec 07, 2017 11:20 pm ] |
Post subject: | Re: Rear Mini Wiring Loom |
winabbey wrote: I have a feeling the same loom was used but the fuel pump wire just taped up out of the way on the Mini K. I wonder if a Mini K owner could check their car and report back? Doug, Our Mini K is fairly early - YG2S1 776 - and has no white wire in the rear harness. Attachment: Harnessplug02.jpg Attachment: Harnessplug01.jpg
|
Author: | winabbey [ Fri Dec 08, 2017 5:59 am ] |
Post subject: | Re: Rear Mini Wiring Loom |
Tim I wrote: Doug, Our Mini K is fairly early - YG2S1 776 - and has no white wire in the rear harness. Ah OK, thanks. So the Cooper S had a different rear harness to the other models without electric pump. All adds to the knowledge base. |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |