ausmini https://www.ausmini.com/forums/ |
|
1970 mini C.S https://www.ausmini.com/forums/viewtopic.php?f=2&t=96654 |
Page 1 of 1 |
Author: | p7676 [ Fri Jan 19, 2018 3:11 pm ] |
Post subject: | 1970 mini C.S |
I have just fitted new discs and bearings etc the kit comes with a machined flat washer about 4mm thick which is to go behind of the castellated nut .Problem is when you use this washer you cannot get a split pin in the hole because the nut is out too far.I have left the washer off and tightened the nut to 150 FP.Anyone had this problem ? Allen |
Author: | slacko [ Fri Jan 19, 2018 3:17 pm ] |
Post subject: | Re: 1970 mini C.S |
The fat washer is used to seat the drive flange on the cv shaft once the flange is seated the flat washer is removed and the split tapered washer is put on and torqued up so yes you have it right |
Author: | Fallingbrick [ Fri Jan 19, 2018 3:20 pm ] |
Post subject: | Re: 1970 mini C.S |
Shouldn't it be a cone split washer for the larger Cooper S CV joints? Haynes refer to a flat washer for seating the hub bearings, which is then removed and the cone type fitted (FAM9270). |
Author: | slacko [ Fri Jan 19, 2018 3:24 pm ] |
Post subject: | Re: 1970 mini C.S |
Yes cone washer , tapered washer you can use the flat washer to push the cone washer in square if you like |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |