Hi all,
If I drive along in 3rd for a bit then back off it jumps out of 3rd, could someone please tell me what options I have. And thank to the people who have helped me out already, great forum
| ausmini https://www.ausmini.com/forums/ |
|
| Popping out of 3rd gear https://www.ausmini.com/forums/viewtopic.php?f=2&t=96658 |
Page 1 of 1 |
| Author: | mystq [ Sat Jan 20, 2018 5:04 pm ] |
| Post subject: | Popping out of 3rd gear |
Hi all, If I drive along in 3rd for a bit then back off it jumps out of 3rd, could someone please tell me what options I have. And thank to the people who have helped me out already, great forum
|
|
| Author: | Goldbrocade_62 [ Sat Jan 20, 2018 5:57 pm ] |
| Post subject: | Re: Popping out of 3rd gear |
Check engine mounts steadies gearbox mounts but more probably internal |
|
| Author: | gtogreen1969 [ Sat Jan 20, 2018 6:01 pm ] |
| Post subject: | Re: Popping out of 3rd gear |
If its a rod change box then it could be worn or loose parts in the shifting mechanism. A loose gearlever, worn internal yoke or broken rubber mounts can cause it to pop out of gear. |
|
| Author: | drmini in aust [ Sat Jan 20, 2018 6:02 pm ] |
| Post subject: | Re: Popping out of 3rd gear |
Any of the following: Wear of 3rd gear and synchro hub drive dogs, weak synchro hub springs, Worn 3-4 selector fork, Weak detent spring(s), End float in 3rd gear. |
|
| Author: | gtogreen1969 [ Sat Jan 20, 2018 6:07 pm ] |
| Post subject: | Re: Popping out of 3rd gear |
Here is a bit of info on the rod change if you also have a sloppy gearchange. https://www.moke.com.au/in-the-garage/g ... gearchange Hope its not an internal box issue. Good luck. |
|
| Author: | Harley [ Sat Jan 20, 2018 6:33 pm ] |
| Post subject: | Re: Popping out of 3rd gear |
Mine did that after fitting a new rubber boot / gaiter thingy to the rod change unit. The new one was too long and pushing against the collar with the roll pins in it. 
|
|
| Author: | Quick 850 [ Sun Jan 21, 2018 10:48 am ] |
| Post subject: | Re: Popping out of 3rd gear |
mystq wrote: Hi all, It will be the dog teeth on the gear and sink hub . If I drive along in 3rd for a bit then back off it jumps out of 3rd, could someone please tell me what options I have. And thank to the people who have helped me out already, great forum Sent from my SM-G930F using Tapatalk |
|
| Author: | goodie [ Mon Jan 22, 2018 7:48 am ] |
| Post subject: | Re: Popping out of 3rd gear |
In your post that you put up when you brought the car you said that it came with receipts , is there any paperwork amongst it that shows that any thing had been done to the gearbox? |
|
| Author: | John Smidt [ Mon Jan 22, 2018 11:23 am ] |
| Post subject: | Re: Popping out of 3rd gear |
If it is a rod change, check 1) gear lever, 2) connecting coupling 3) gear Lever locating pin in selector housing. If it is not a Rod Change type check the selector toggles, make sure they are aligned correctly and they are tight, The above may fix your problem if not then my guess is it is internal, which may have been caused by problems mentioned above |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|