ausmini
https://www.ausmini.com/forums/

How to Remove this Bearing?
https://www.ausmini.com/forums/viewtopic.php?f=2&t=96834
Page 1 of 1

Author:  cooperess [ Sat Feb 17, 2018 1:08 pm ]
Post subject:  How to Remove this Bearing?

Attachment:
Mini Gear Box Nut Removal 001.jpg
How does one remove this bearing without wrecking it like I have.

Author:  hpal [ Sat Feb 17, 2018 1:37 pm ]
Post subject:  Re: How to Remove this Bearing?

I would assume use a suitable puller, its a need roller yes?

Author:  simon k [ Sat Feb 17, 2018 2:17 pm ]
Post subject:  Re: How to Remove this Bearing?

I have a little 3 leg puller I use - I think I had to grind the feet a little thinner to get between the ring and the nut, but that's the way I do it...

Author:  cooperess [ Sat Feb 17, 2018 2:18 pm ]
Post subject:  Re: How to Remove this Bearing?

hpal wrote:
I would assume use a suitable puller, its a need roller yes?
It was until I broke the cage and the needles dropped out.

Author:  Phil 850 [ Sat Feb 17, 2018 2:22 pm ]
Post subject:  Re: How to Remove this Bearing?

Attachment:
IMG_3830.JPG

I made one of these from a piece of 50mm square tube.

Author:  cgo [ Sat Feb 17, 2018 2:23 pm ]
Post subject:  Re: How to Remove this Bearing?

Have used a small 2 jaw puller.
Or read this;
http://www.ausmini.com/forums/viewtopic.php?f=25&t=66729
Attachment:
puller.JPG


Sorry, too late.

Author:  AEG163job [ Sat Feb 17, 2018 8:27 pm ]
Post subject:  Re: How to Remove this Bearing?

Removing the bearing from the shaft is easy. Removing the outer shell from the transmission casing is much more fun (which you will now need to do since you've totalled the inner part! :evil:

Author:  cooperess [ Sat Feb 17, 2018 8:41 pm ]
Post subject:  Re: How to Remove this Bearing?

Thanks for your guys.

Author:  peterb [ Sun Feb 18, 2018 6:55 am ]
Post subject:  Re: How to Remove this Bearing?

AEG163job wrote:
Removing the bearing from the shaft is easy. Removing the outer shell from the transmission casing is much more fun (which you will now need to do since you've totalled the inner part! :evil:


Easy. Just run a weld around inside of shell, it'll just fall out......into the trash.

Author:  kiwiinwgtn [ Fri Feb 23, 2018 5:51 pm ]
Post subject:  Re: How to Remove this Bearing?

cgo wrote:
Have used a small 2 jaw puller.
Or read this;
http://www.ausmini.com/forums/viewtopic.php?f=25&t=66729
Attachment:
puller.JPG


Sorry, too late.


Nice to see my link in use,
Pitty about photobucket issues

Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/