As per title would have a the standard height of a cylinder block. I have one in good condition but it looks to have had a couple of mill shaved off the top. Looking to hopefully use it to build a stroker engine. May need to get the piston dish machined to reduce the compression ratio so I can use it.

Ta Kiwiinwgtn

I will measure one in the morning.
Re the pistons, hypatecs are good for strokers as the rings are lower than most others, allowing more to be machined off the top. I reshaped the dish similar to GR's ones.

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R.

227mm measured with a new Stanley tape.
Standard block still has bore size stampings on.

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R.

My stroker has hypatecs done by GR There is 10cc in each piston dish

thanks for the replys

Sent from my SM-J530Y using Tapatalk