ausmini https://www.ausmini.com/forums/ |
|
C.S Mark2 dash trim https://www.ausmini.com/forums/viewtopic.php?f=2&t=97146 |
Page 1 of 1 |
Author: | p7676 [ Sun Apr 29, 2018 5:24 pm ] |
Post subject: | C.S Mark2 dash trim |
Hello All, Just fitted the black vinyl dash trims ,top trim is easy to fit. The bottom trim which is the one where the switch panel is, a pain to fit .Although it is done now. I only have approx. 2 or 3 mm of vinyl in the opening where the switch panel fits. The aluminum switch trim just covers the vinyl .Has anyone had the vinyl shrink which would show the paint ? The aluminum switch panel trim should have been larger and made from SS. Took me 4 hours to do a 1 hour job. Allen |
Author: | Goldbrocade_62 [ Sun Apr 29, 2018 6:18 pm ] |
Post subject: | Re: C.S Mark2 dash trim |
When I have done them they haven't shrunk back yet |
Author: | Bill B [ Sun Apr 29, 2018 7:53 pm ] |
Post subject: | Re: C.S Mark2 dash trim |
p7676 wrote: Hello All, Just fitted the black vinyl dash trims ,top trim is easy to fit. The bottom trim which is the one where the switch panel is, a pain to fit .Although it is done now. I only have approx. 2 or 3 mm of vinyl in the opening where the switch panel fits. The aluminum switch trim just covers the vinyl .Has anyone had the vinyl shrink which would show the paint ? The aluminum switch panel trim should have been larger and made from SS. Took me 4 hours to do a 1 hour job. Allen Sounds about right. The original vinyl doesn't shrink. If there was a lot of vinyl over-lapping the opening, I think the trim piece would not be able to hold back 2 thicknesses of vinyl. No restoration job is predictable because you aren't doing it all the time. If you planned on it being a 4 hour job you'd be pleased it was on time! |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |