| ausmini https://www.ausmini.com/forums/ |
|
| slave cylinder c.s mk 2 https://www.ausmini.com/forums/viewtopic.php?f=2&t=97255 |
Page 1 of 1 |
| Author: | p7676 [ Sat May 26, 2018 2:53 pm ] |
| Post subject: | slave cylinder c.s mk 2 |
The spring on the slave cylinder is extremely hard to connect. Should I screw in the 1/4 bolt ? New clutch and slave cylinder have been fitted any ideas ? TY Allen |
|
| Author: | Bill B [ Sat May 26, 2018 6:19 pm ] |
| Post subject: | Re: slave cylinder c.s mk 2 |
Yes. It is a little bugger... I have copied a friend's idea to reduce the tension in the spring as it doesn't need to be so strong. A short length of steel wire/rod (even a nail) bent at both ends to go between the spring end and triangle plate on the clutch arm. Just needs to have slight tension all the time. |
|
| Author: | Matt I [ Sat May 26, 2018 10:18 pm ] |
| Post subject: | Re: slave cylinder c.s mk 2 |
Drop it in your toolbox and forget it was ever there... They don't need it and the clutch mechanism works better without. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|