ausmini https://www.ausmini.com/forums/ |
|
choke heater accel cable holes. https://www.ausmini.com/forums/viewtopic.php?f=2&t=97364 |
Page 1 of 1 |
Author: | p7676 [ Thu Jun 14, 2018 6:24 pm ] |
Post subject: | choke heater accel cable holes. |
Are the 3 same dia holes located on the firewall just above the support panel used for the cables ? Allen |
Author: | gtogreen1969 [ Thu Jun 14, 2018 7:33 pm ] |
Post subject: | Re: choke heater accel cable holes. |
p7676 wrote: Are the 3 same dia holes located on the firewall just above the support panel used for the cables ? I think the centre one is blanked off.
Allen |
Author: | Bill B [ Fri Jun 15, 2018 1:08 pm ] |
Post subject: | Re: choke heater accel cable holes. |
Ditto gtogreen. That's what my 8/70 S has too. Heater cable through driver's side hole, choke through LH hole. I put a blanking grommet in the middle. Some earlier minis did not have the centre hole punched out although there was an outline for it like the other 2 in the bottom edge of the dash panel. |
Author: | DavidE [ Fri Jun 15, 2018 5:14 pm ] |
Post subject: | Re: choke heater accel cable holes. |
p7676 wrote: Are the 3 same dia holes located on the firewall just above the support panel used for the cables ? Allen The accelerator cable exits through the firewall in line with the top of the accelerator arm. It is below the firewall cross-member. |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |