ausmini https://www.ausmini.com/forums/ |
|
Wiper rack re-instal issue - pic requested https://www.ausmini.com/forums/viewtopic.php?f=2&t=97628 |
Page 1 of 1 |
Author: | BBY755 [ Sat Aug 11, 2018 5:17 pm ] |
Post subject: | Wiper rack re-instal issue - pic requested |
Hi all, Re-fitting 1970 wiper rack assembly complete and found that can't get the tube that fits onto wiper motor far enough away to fit - replaced wiper spindle bodies in the same place, and loosened everything but can't get it to fit and don't want to bend the tube as was exactly as taken off...... Would anyone have a pic of a complete assembly fitted? Just in case I had a brain fade and did something totally dumb (quite possible) Thanks in advance |
Author: | Mozzie [ Sat Aug 11, 2018 5:24 pm ] |
Post subject: | Re: Wiper rack re-instal issue - pic requested |
I had a similar issue. I had installed wiper spindles out by 180 deg. Disassemble shaft and tubes, rotate spindles assemblies 180 deg and reinstall. |
Author: | BBY755 [ Sat Aug 11, 2018 5:33 pm ] |
Post subject: | Re: Wiper rack re-instal issue - pic requested |
Thanks - will do. Been a long day...need beer..... |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |