These appear really tight and the u bolt spread a little larger than hole alignment
Any experience with these ?
Should I bend the bolt and jam it in?
Sent from my iPhone using Tapatalk
| ausmini https://www.ausmini.com/forums/ |
|
| New rubber uni joints https://www.ausmini.com/forums/viewtopic.php?f=2&t=97834 |
Page 1 of 1 |
| Author: | simonw [ Wed Oct 10, 2018 12:38 pm ] |
| Post subject: | New rubber uni joints |
These appear really tight and the u bolt spread a little larger than hole alignment Any experience with these ? Should I bend the bolt and jam it in? Sent from my iPhone using Tapatalk |
|
| Author: | 9YaTaH [ Wed Oct 10, 2018 12:48 pm ] |
| Post subject: | Re: New rubber uni joints |
Yes...the U Bolts spring "open"...gently squeeze them in a vice or gently tap with a BFH close to the threaded end or run 2-3 old nuts on each end before hitting or clamping (to save damaging the threads)...then they should slide right in... |
|
| Author: | simonw [ Wed Oct 10, 2018 5:44 pm ] |
| Post subject: | Re: New rubber uni joints |
Many thanks 9ya, it had me a little ba’fooled’ Sent from my iPad using Tapatalk |
|
| Author: | 9YaTaH [ Thu Oct 11, 2018 10:01 pm ] |
| Post subject: | Re: New rubber uni joints |
simonw wrote: Many thanks 9ya, it had me a little ba’fooled’ Sent from my iPad using Tapatalk No problem simon...advice and help is what AUSMINI is all about  
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|