Hi all,
I'm building a 1275 A+. Just went to put the standard crank back in with std ACL thrust washers.
They are way to tight, can only just turn crank and have next to no end float.
Have I got the wrong washers? They are ACL 2T2204-STD KC number is BHM1293 STD
They measure .092 thou so sound right.
Any help would be appreciated.
Cheers Pete

_________________
A recent study found the average Aussie walks about 900 miles a year
Another study found Aussies drink, on average, 22 gallons of alcohol a year
That means, on average, Australians get about 41 miles per gallon

Kind of makes you proud to be an AUSSIE

Sand the back down on some wet and dry 180 paper. Measure with a micrometer.
BTW 3 thou end float is too tight make clearance 5 thou + measured with a dial gauge. If you are going to rev it to 7000.
Edit- I use .007" end float.

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R.

Drmini,
Thank you for the help and advice. Greatly appreciated.
Cheers Pete

_________________
A recent study found the average Aussie walks about 900 miles a year
Another study found Aussies drink, on average, 22 gallons of alcohol a year
That means, on average, Australians get about 41 miles per gallon

Kind of makes you proud to be an AUSSIE

Mine had to be surface ground on a machine with a magnetic attachment to get the 5 thou
Material taken off steel side