ausmini
https://www.ausmini.com/forums/

Engine Bay Cleaning
https://www.ausmini.com/forums/viewtopic.php?f=2&t=98710
Page 1 of 1

Author:  edcomm [ Sat Jun 22, 2019 11:34 am ]
Post subject:  Engine Bay Cleaning

Hi All

Just bought my first Mini (66 Deluxe) and the engine bay is pristine. I'd like to keep it that way. I'd be very grateful for any cleaning / product tips and recommendations? Aside from avoiding muddy and wet roads :)

Thanks

Ed

Author:  Bill B [ Sat Jun 22, 2019 2:14 pm ]
Post subject:  Re: Engine Bay Cleaning

Welcome to the mini world.
The VIN numbers and paperwork must have added up.
Sorry your first post got hijacked by a few of us who wanted to vent about our problems experienced with car numbers etc.

We spray a degreaser over most of the engine and bay sides (avoid distributor and leads) and hose off. An old style dishwashing mop fits into corners.
If you have heater hoses going through the box channel on passenger side, be careful of water dripping onto carpet inside the car.

Author:  edcomm [ Wed Jul 03, 2019 9:05 pm ]
Post subject:  Re: Engine Bay Cleaning

Hi Bill- yes all the numbers matched up so all good, it’s a great little car. Thanks for the tips!

Ed

Author:  9YaTaH [ Thu Jul 04, 2019 8:05 am ]
Post subject:  Re: Engine Bay Cleaning

Wot Bill said and I would bag the distributor...a rubber washing up glove can also be used with the end of the fingers cut off (ahhhhh, memories)

I for one do not apologise for any AUSMINI scrutiny of your car numbers...I think some here are doing a top job at pointing out anomalies with cars offered for sale...I would rather know that any car I bought was kosher or not...especially if it had been previously stolen etc where you might have to forfeit "ownership" after paying your hard earned for it :!:

Author:  edcomm [ Thu Jul 04, 2019 7:35 pm ]
Post subject:  Re: Engine Bay Cleaning

Rubber glove tip is excellent! Thank you!

Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/