| ausmini https://www.ausmini.com/forums/ |
|
| Help needed - MK2 Firewall measurements https://www.ausmini.com/forums/viewtopic.php?f=2&t=99709 |
Page 1 of 1 |
| Author: | gtogreen1969 [ Sun Feb 23, 2020 1:24 pm ] |
| Post subject: | Help needed - MK2 Firewall measurements |
I don't have access to a MK2 firewall and need to get the measurements for the extra 2 nutserts for the speedo binnacle. Can anyone help by measuring the distance from the speedo hole to the binnacle screw holes as below. Thanks Attachment: MK2 Firewall binnacle nut holes.jpg
|
|
| Author: | winabbey [ Sun Feb 23, 2020 1:48 pm ] |
| Post subject: | Re: Help needed - MK2 Firewall measurements |
Exactly 4" each side. Distance between the two holes is 1' 2 7/8" (that's one foot plus two and seven eighths inches). |
|
| Author: | gtogreen1969 [ Sun Feb 23, 2020 1:52 pm ] |
| Post subject: | Re: Help needed - MK2 Firewall measurements |
winabbey wrote: Exactly 4" each side. Distance between the two holes is 1' 2 7/8" (that's one foot plus two and seven eighths inches). Thanks mate. I am helping out a chap to ID his car and it has lots of conveniently placed holes drilled out on the firewall where a body stamps and binnacle nuts would normally go. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|