Ausmini
It is currently Tue Apr 23, 2024 9:01 pm

All times are UTC + 10 hours




Post new topic Reply to topic  [ 12 posts ] 
Author Message
 Post subject: Poor running
PostPosted: Tue Apr 07, 2020 5:17 pm 
Offline
1275cc
1275cc

Joined: Wed Jan 05, 2005 4:50 pm
Posts: 2690
Location: Wollongong
Hi all,

Haven’t driven the car in a few months as it needed a new fuel pump.

Changed the pump, which lead to more pressure which caused the fuel filter to leak. Changed that, which lead to one of the fuel bowls to leak. Fixed that.

Started the car. Started first go. Let it warm up a little. Reversed out the driveway, into first gear. Took off okay but then bogged down. It almost had no power. Revs okay at idle, but under load it bogs down and has no go.

What should I be checking.

Plugs were very black, so gave them a clean.
There is spark at all four leads, however when I pull the leads off the two passenger side cylinders there is almost no change.

Any advice would be much appreciated.

_________________
Ryan Filippi
Minis In The Gong
ryan@minisinthegong.com.au
www.minisinthegong.com.au


Top
 Profile  
 
 Post subject: Re: Poor running
PostPosted: Tue Apr 07, 2020 5:41 pm 
Offline
1275cc
1275cc

Joined: Wed Jan 19, 2005 1:52 pm
Posts: 2572
Location: Brisbane
Did you change the fuel? I reckon that it's gone stale.

EDIT: you have twin SUs? Stale fuel has gummed up one of the carbs is my bet.

_________________
The bitterness of poor quality (or Crappy Workmanship) remains LONG AFTER the Sweet Taste of Low Price is forgotten.


Last edited by TK on Tue Apr 07, 2020 5:53 pm, edited 1 time in total.

Top
 Profile  
 
 Post subject: Re: Poor running
PostPosted: Tue Apr 07, 2020 5:45 pm 
Offline
1275cc
1275cc
User avatar

Joined: Sun Apr 29, 2012 1:19 pm
Posts: 4350
Location: Wollongong, NSW
Maybe also check the dashpot oil

_________________
Image


Top
 Profile  
 
 Post subject: Re: Poor running
PostPosted: Tue Apr 07, 2020 6:28 pm 
Offline
1275cc
1275cc

Joined: Wed Jan 05, 2005 4:50 pm
Posts: 2690
Location: Wollongong
What’s the best way to test for stale fuel without dropping everything in the tanks? Run a hose to a jerry can?

How would you go about cleaning a gummed up su?

_________________
Ryan Filippi
Minis In The Gong
ryan@minisinthegong.com.au
www.minisinthegong.com.au


Top
 Profile  
 
 Post subject: Re: Poor running
PostPosted: Tue Apr 07, 2020 6:51 pm 
Offline
1275cc
1275cc

Joined: Wed Jan 19, 2005 1:52 pm
Posts: 2572
Location: Brisbane
See if the piston lifts and drops freely first. Does fuel flow from the bowl to the jet? If not maybe there is a product for cleaning?

_________________
The bitterness of poor quality (or Crappy Workmanship) remains LONG AFTER the Sweet Taste of Low Price is forgotten.


Top
 Profile  
 
 Post subject: Re: Poor running
PostPosted: Tue Apr 07, 2020 7:01 pm 
Offline
1275cc
1275cc

Joined: Wed Jan 05, 2005 4:50 pm
Posts: 2690
Location: Wollongong
TK, you just jogged my memory. The piston had seized about 6 months ago, causing the same issue which I easily fixed. I’m almost certain this will be the problem.

_________________
Ryan Filippi
Minis In The Gong
ryan@minisinthegong.com.au
www.minisinthegong.com.au


Top
 Profile  
 
 Post subject: Re: Poor running
PostPosted: Wed Apr 08, 2020 7:07 am 
Offline
1360cc
1360cc
User avatar

Joined: Sun Apr 11, 2004 11:32 am
Posts: 12390
Location: Sthrn HiLoLands, NSW, Australia
What sort of fuel pump? If aftermarket, maybe you need a regulator...

_________________
"Show me the Mini!"


Top
 Profile  
 
 Post subject: Re: Poor running
PostPosted: Wed Apr 08, 2020 8:53 am 
Offline
1275cc
1275cc
User avatar

Joined: Sun Apr 29, 2012 1:19 pm
Posts: 4350
Location: Wollongong, NSW
It’s a mechanical pump

_________________
Image


Top
 Profile  
 
 Post subject: Re: Poor running
PostPosted: Sat Apr 11, 2020 3:38 pm 
Offline
1275cc
1275cc

Joined: Wed Jan 05, 2005 4:50 pm
Posts: 2690
Location: Wollongong
As Tim said, it’s a mechanical pump.

The carbs are twin 1 1/4 inch SU.

I had a quick look this morning and the jet on the bottom of the passenger side carb was stuck out. I released it will a little wiggle.

This has happened before?
How do you all recommend tackling this?

New kit through the carbs?
Clean and lube? How would you do this?

Any advice welcome.

_________________
Ryan Filippi
Minis In The Gong
ryan@minisinthegong.com.au
www.minisinthegong.com.au


Top
 Profile  
 
 Post subject: Re: Poor running
PostPosted: Sat Apr 11, 2020 6:24 pm 
Offline
Yay For Hay!
User avatar

Joined: Wed Sep 08, 2004 9:27 pm
Posts: 15870
Location: Wodonga - Vic/NSW border
it's probably more the linkage binding somewhere than the jet being stuck down - see if you can get it to stick down by playing with the cable/linkage/jet and fix whatever is making it stick

_________________
did I tell you that I won a trophy?


Top
 Profile  
 
 Post subject: Re: Poor running
PostPosted: Sat Apr 11, 2020 7:43 pm 
Offline
848cc
848cc

Joined: Sun Mar 16, 2014 11:01 am
Posts: 456
Location: TOWNSVILLE NQ
Centralise the jet.


Top
 Profile  
 
 Post subject: Re: Poor running
PostPosted: Tue Apr 14, 2020 9:04 pm 
Offline
1275cc
1275cc

Joined: Wed Jan 05, 2005 4:50 pm
Posts: 2690
Location: Wollongong
Bit of a clean and jiggle and the jet is returning just fine.

Ran like a dream. I’m a happy man again.

_________________
Ryan Filippi
Minis In The Gong
ryan@minisinthegong.com.au
www.minisinthegong.com.au


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 12 posts ] 

All times are UTC + 10 hours


Who is online

Users browsing this forum: jpodge and 23 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  

© 2016 Ausmini. All garage work involves equal measures of enthusiasm, ingenuity and a fair degree of irresponsibility.