| ausmini https://www.ausmini.com/forums/ |
|
| V-tec Moke https://www.ausmini.com/forums/viewtopic.php?f=23&t=82955 |
Page 1 of 1 |
| Author: | leylandbrother [ Tue Oct 01, 2013 9:40 am ] |
| Post subject: | V-tec Moke |
Has any one done a V-tec moke here in Victoria If so is there a sub frame supplier in Oz Cheers Carl |
|
| Author: | simon k [ Tue Oct 01, 2013 12:08 pm ] |
| Post subject: | Re: V-tec Moke |
leylandbrother wrote: Has any one done a V-tec moke here in Victoria If so is there a sub frame supplier in Oz Cheers Carl not that I know of and no supplier in Australia |
|
| Author: | Irish Yobbo [ Tue Oct 01, 2013 12:33 pm ] |
| Post subject: | Re: V-tec Moke |
As far as I know, there is no out-of-the-box solution in Australia. You can buy kits from overseas, but they will still need to be engineer approved in Australia. |
|
| Author: | leylandbrother [ Wed Oct 02, 2013 2:21 pm ] |
| Post subject: | Re: V-tec Moke |
BJ tells me they do a complete Moke set up ... Any one delt with them here? http://rover.ebay.com/rover/0/e11051.m4 ... AAU%3A1123 |
|
| Author: | _666_ [ Wed Oct 02, 2013 7:01 pm ] |
| Post subject: | Re: V-tec Moke |
bj of Minitec (www.superfastminis.com) is one of the 3 main suppliers of subframes (and conversion kits) for VTEC mini's and the only supplier who advertises "moke designated" frames a few people have gotten minitec frames passed by the engineer now, so you shouldnt have a problem, but dont think its a bolt in solution, there is cutting and welding involved for all RHD vehicles |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|