Ausmini
It is currently Fri Feb 22, 2019 4:19 am

All times are UTC + 10 hours




Forum locked This topic is locked, you cannot edit posts or make further replies.  [ 1 post ] 
Author Message
PostPosted: Wed Nov 03, 2010 8:15 pm 
Offline
the King of Bling
User avatar

Joined: Thu Jun 03, 2004 11:11 pm
Posts: 19853
Location: Baulkham Hills
This is the puller I made up from the kind instructions of Matt The Miniman As I had to remove yet another damaged bearing the other day after a friend had a go at removing it with a screwdriver.

So take a piece of 50mm x 25mm RHS about a foot long will do,,, cut a slot in the 50 side just big enough for the shaft,,, drill a hole in the opposit side & weld a big nut onto it,,, then slip the RHS over the bearing & lock into the shaft & wind the bolt in through the nut till it engages the shaft, & simply keep winding, it will pull it off , un-harmed, cage & rollers & all, no damage, quick as a wink & easy-peas

Image

Image


Image

Thanks

Kiwiinwgtn

_________________
Stop Licking the Dog...I Don't Care Who Started It


Top
 Profile  
 
Display posts from previous:  Sort by  
Forum locked This topic is locked, you cannot edit posts or make further replies.  [ 1 post ] 

All times are UTC + 10 hours


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  

cron

© 2016 Ausmini. All garage work involves equal measures of enthusiasm, ingenuity and a fair degree of irresponsibility.