ausmini
https://www.ausmini.com/forums/

Fitting front indicator beehive lens the simple way.
https://www.ausmini.com/forums/viewtopic.php?f=25&t=90777
Page 1 of 1

Author:  kiwiinwgtn [ Sun Oct 11, 2015 8:54 pm ]
Post subject:  Fitting front indicator beehive lens the simple way.

I battled with fitting new rubber boots to my indicators today.

After much swearing I figured on this process.

Figure out which way the bulb holder needs to go to screw in easily
Fit the boot over the wires.
Fit bulb holder
Fit screws thru the holder and the boot.
Fit chrome ring without lense
Screw holder to car with the ring attached to the boot.
Remove ring and fit lens
Push lens into rubber and use a small non sharp tool to tease the rubber over the chrome ring.

By screwing the holder onto the car with the chrome lens attached it flatens the rubber it to the correct postion when the lens is fitted.

By doing the above it makes fitting the lens way easier.

Good Luck

Kiwiinwgtn

Author:  Phil 850 [ Sun Oct 11, 2015 9:01 pm ]
Post subject:  Re: Fitting front indicator beehive lens the simple way.

Looks like another How To !
Didn't take photos did you

Author:  DavidE [ Sun Oct 18, 2015 1:55 pm ]
Post subject:  Re: Fitting front indicator beehive lens the simple way.

kiwiinwgtn wrote:
I battled with fitting new rubber boots to my indicators today.

After much swearing I figured on this process.

Figure out which way the bulb holder needs to go to screw in easily
Fit the boot over the wires.
Fit bulb holder
Fit screws thru the holder and the boot.
Fit chrome ring without lense
Screw holder to car with the ring attached to the boot.
Remove ring and fit lens
Push lens into rubber and use a small non sharp tool to tease the rubber over the chrome ring.

By screwing the holder onto the car with the chrome lens attached it flatens the rubber it to the correct postion when the lens is fitted.

By doing the above it makes fitting the lens way easier.

Good Luck

Kiwiinwgtn


Bloody brilliant. Never has such an easy time of it doing these two lights as today, by following these instructions. Thanks!!

Author:  Mick [ Sun Oct 18, 2015 4:18 pm ]
Post subject:  Re: Fitting front indicator beehive lens the simple way.

Thanks again to kiwiinwgtn for this How-To :)

Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/