| ausmini https://www.ausmini.com/forums/ |
|
| Easy mods for 7 port extractors https://www.ausmini.com/forums/viewtopic.php?f=5&t=96378 |
Page 1 of 1 |
| Author: | Ian_B [ Tue Nov 28, 2017 8:19 pm ] |
| Post subject: | Easy mods for 7 port extractors |
My mate did this Very easy with mig and cutting disc and drill |
|
| Author: | Ian_B [ Mon Dec 04, 2017 8:34 pm ] |
| Post subject: | Re: Easy mods for 7 port extractors |
Ive seen something on a lathe done to make inserts to do this This is easy when a mate is a boily and not a machinist He did a top job He has a new cheap TV lol |
|
| Author: | justfanginaround [ Tue Dec 05, 2017 5:04 pm ] |
| Post subject: | Re: Easy mods for 7 port extractors |
the 7 port I purchased from Webcon UK came with 2 alloy spacers to make a bridge where the original inlet manifold would of gone, had to machine them down a tad to be the same height as my pipes. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|