ausmini
https://www.ausmini.com/forums/

Specialist Components 7 port head
https://www.ausmini.com/forums/viewtopic.php?f=5&t=99812		 Page 1 of 1
Author:  Damo1360 [ Fri Apr 03, 2020 8:38 am ]
Post subject:  Specialist Components 7 port head
Hi Guys,

New to this forum, Im in need of some assistance been building my mini for the past 12 years (long I KNOW) I have installed a SC 7 port head with fuel injection,
has anyone had any experience with the fuel system mapping...... the 1380 download just doesn't seem to cut it to run correctly :?: , any assistance would be much appreciated.
Author:  justfanginaround [ Sat Apr 04, 2020 4:23 am ]
Post subject:  Re: Specialist Components 7 port head
What efi system are you using ? what ecu ? what are the specs are of engine ?

And whats your location ?
Author:  simon k [ Thu Apr 09, 2020 5:18 pm ]
Post subject:  Re: Specialist Components 7 port head
I don't know if anyone on here has an SC injected 7 port to give advice, but every engine is different anyway - what works for one persons engine could be a long way off for someone elses

the downloadable maps would give you a rough starting point that you'd work from on a dyno

I'd love to have a play with it and have a couple of friendly dyno operators who would be up for it, but I don't know where you are, what's your location? (put it in your profile)
Author:  Oscar [ Fri Apr 10, 2020 10:03 am ]
Post subject:  Re: Specialist Components 7 port head
MiniBob on here put an SC 7-port on his Mini. viewtopic.php?f=5&t=84969

Don't know that he comes on here much nowadays but you can try him with a PM.
Author:  MiniBob [ Sat Apr 11, 2020 5:50 pm ]
Post subject:  Re: Specialist Components 7 port head
Well its up and running after downloading and using the SC software for my Typhoon ECU. If I recall they do different software for each version of ECU.
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/