ausmini https://www.ausmini.com/forums/ |
|
3D printed HS4 air inlet. https://www.ausmini.com/forums/viewtopic.php?f=5&t=99915 |
Page 1 of 1 |
Author: | Floyd1098 [ Tue Apr 21, 2020 9:15 am ] |
Post subject: | 3D printed HS4 air inlet. |
Hi. Thought this might be of interest, found this on a 3D printing site. https://community.ultimaker.com/files/f ... -mini-hs4/ Retains the elbow. Very interesting. |
Author: | Floyd1098 [ Tue Apr 21, 2020 9:17 am ] |
Post subject: | Re: 3D printed HS4 air inlet. |
Sorry, it doesn't use the elbow it replaces the whole thing. |
Author: | Kennomini [ Wed Apr 22, 2020 2:33 pm ] |
Post subject: | Re: 3D printed HS4 air inlet. |
That may not fit a RHD mini due to the master cylinders.. |
Author: | Ian_B [ Sat Apr 25, 2020 8:09 pm ] |
Post subject: | Re: 3D printed HS4 air inlet. |
If they can do that then they can make intake manifolds for aftermarket 7 and 8 port heads also Bike carbs |
Page 1 of 1 | All times are UTC + 10 hours |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |