It is listed as an "Air Grease Pump" but it is not an air pump, it is a manual one. But it should work as a hydro pump.
25bar = 362.59psi.

I was thinking of converting one of these...


To make the flashest and most expensive hydro pump in the world. I have one that I don't use much and it is almost going to waste.
Could you imagine just pulling the trigger and about ten seconds later the car is sitting on its belly in a pool of green liquid.

very interesting thread..... until it degenerated into hydro pumps - I've a mind to mod those out

_________________
did I tell you that I won a trophy?

I'm going to buy a set of them....

but check this one out - dent puller kit

it's a hot glue gun, with a little bridge thingy that goes over the dent, and little feet that you glue to the dent. Thread the foot through the bridge and screw it down, and it pulls the dent up.

I've got a little ding in my roof that this would be ideal for - I'll make my own tho, hot glue guns are awesome

A body work artist (way beyond panel beater) I used to visit had the same thing but it welded itself to the centre of the dent and you pulled it up, then just ground the bit of weld off

_________________
did I tell you that I won a trophy?

Yep you can buy attachments for a Binzel MIG torch to weld studs on.
Would go well next to my/our carbon electrode MIG panel shrinking tool...

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R.

jeez, I forgot about that!! - I still can't use it because I haven't put in a 20A power point for my welder...

_________________
did I tell you that I won a trophy?