| ausmini https://www.ausmini.com/forums/ |
|
| What is this hole https://www.ausmini.com/forums/viewtopic.php?f=2&t=100170 |
Page 1 of 1 |
| Author: | Stibbsy [ Sun Jul 05, 2020 1:13 pm ] |
| Post subject: | What is this hole |
IMG_9274.jpeg I think the motor is from late model moke |
|
| Author: | drmini in aust [ Sun Jul 05, 2020 2:20 pm ] |
| Post subject: | Re: What is this hole |
Dowel hole. There is another down the bottom, behind your hand. To align the flywheel housing with the gearbox casing. |
|
| Author: | Stibbsy [ Sun Jul 05, 2020 7:18 pm ] |
| Post subject: | Re: What is this hole |
drmini in aust wrote: Dowel hole. There is another down the bottom, behind your hand. To align the flywheel housing with the gearbox casing. Thanks Doc, It's a 1275 motor that is going into a Deluxe. Looks like it is a bit of hybrid though. No dowel where the hole is. Not all early idler/clutch housings have that hole though. |
|
| Author: | drmini in aust [ Sun Jul 05, 2020 8:50 pm ] |
| Post subject: | Re: What is this hole |
The dowel in there didn't always align if you mixed housings and gearbox cases. Over the years I built 2 boxes which needed one dowel or the other left out, to align the outrigger bearing. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|