| ausmini https://www.ausmini.com/forums/ |
|
| 1970 Mk2 Angle Brace https://www.ausmini.com/forums/viewtopic.php?f=2&t=100496 |
Page 1 of 1 |
| Author: | Cooper2229 [ Thu Oct 29, 2020 9:28 pm ] |
| Post subject: | 1970 Mk2 Angle Brace |
Hi, Can anybody please let me know the correct location for the front angle brace on a 1970 Mk2 S. I am replacing the front panel (It had an incorrect later fitted) and would like to put it in the right spot. Thanks Dave. |
|
| Author: | winabbey [ Thu Oct 29, 2020 9:42 pm ] |
| Post subject: | Re: 1970 Mk2 Angle Brace |
As a starter have a look here - viewtopic.php?f=2&t=96171&p=1026729 |
|
| Author: | cgo [ Thu Oct 29, 2020 9:46 pm ] |
| Post subject: | Re: 1970 Mk2 Angle Brace |
Does this help, can measure if you wish? |
|
| Author: | Stibbsy [ Fri Oct 30, 2020 9:37 am ] |
| Post subject: | Re: 1970 Mk2 Angle Brace |
When I visited Ron Williams little museum and workshop in Tenterfield in 2013. Didn’t know me from a bar of soap, but took the time to show me around. Wonderfull man, but I digress. Took measurements for installation of the cross brace. 4” (100mm) from the inner panel at the lower and 8” (200mm) at the top. He even cut of a piece of the brace material he uses in resto’s. |
|
| Author: | Cooper2229 [ Fri Nov 06, 2020 4:19 pm ] |
| Post subject: | Re: 1970 Mk2 Angle Brace |
Thank all for your help. I think I have it sorted. Cheers Dave. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|