| ausmini https://www.ausmini.com/forums/ |
|
| Distributor Orientation 421191 https://www.ausmini.com/forums/viewtopic.php?f=2&t=101482 |
Page 1 of 1 |
| Author: | cooperess [ Sun Aug 14, 2022 2:57 pm ] |
| Post subject: | Distributor Orientation 421191 |
There are 2 ways to attached this part. Is the correct way shown in the picture or should it be flipped over with the nut on the left? Attachment: Mini Distributor Clamp 421191 DSCF1414.JPG
|
|
| Author: | 1071 S [ Sun Aug 14, 2022 5:19 pm ] |
| Post subject: | Re: Distributor Orientation 421191 |
I do it that way. The ears bolt to the block and the part that grips the dizzy is slightly raised so holds the dizzy higher towards the reinforcing ring... rather than down the bottom where its not reinforced.... Cheers, Ian |
|
| Author: | Bill B [ Sun Aug 14, 2022 6:09 pm ] |
| Post subject: | Re: Distributor Orientation 421191 |
Ditto. And where the witness marks for the 2 setscrews and the distributor reinforcing ring show which way was up. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|