| ausmini https://www.ausmini.com/forums/ |
|
| Timing https://www.ausmini.com/forums/viewtopic.php?f=2&t=101545 |
Page 1 of 1 |
| Author: | cooperess [ Sat Oct 01, 2022 7:01 pm ] |
| Post subject: | Timing |
Found out why my timing is out by 180 degrees. I rebuilt my dizzy but didn't realise you can put the offset on the shaft both ways. |
|
| Author: | timmy201 [ Sat Oct 01, 2022 7:07 pm ] |
| Post subject: | Re: Timing |
I learned that one the hard way too |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|