| ausmini https://www.ausmini.com/forums/ |
|
| Boot Lid Weather Seal https://www.ausmini.com/forums/viewtopic.php?f=2&t=101556 |
Page 1 of 1 |
| Author: | cooperess [ Fri Oct 07, 2022 8:28 am ] |
| Post subject: | Boot Lid Weather Seal |
I guess many of you have done this job, that is replacing the boot lid seal. I am have difficulties. Any thoughts. Attachment: Mini Boot Lid Weather Seal DSCF1530 (1).JPG
|
|
| Author: | Bill B [ Fri Oct 07, 2022 8:38 am ] |
| Post subject: | Re: Boot Lid Weather Seal |
I have never been able to use those clips with the boot seal. You get a few on, thinking you are winning then the rubber slips off. I end up gluing the strip on. And the clips are quite expensive, too. |
|
| Author: | p7676 [ Fri Oct 07, 2022 8:50 am ] |
| Post subject: | Re: Boot Lid Weather Seal |
use contact cement. easy job |
|
| Author: | 68+86auto [ Fri Oct 07, 2022 9:23 am ] |
| Post subject: | Re: Boot Lid Weather Seal |
The best way I found to put them in was with a 90 degree spot weld chisel. That was after I destroyed a lot and the seal other ways. |
|
| Author: | Shaunsyd [ Fri Oct 07, 2022 12:40 pm ] |
| Post subject: | Re: Boot Lid Weather Seal |
I just pushed them in with a pair of long nosed pliers broke a couple but don't remember having a lot of difficulty |
|
| Author: | Bill B [ Fri Oct 07, 2022 12:54 pm ] |
| Post subject: | Re: Boot Lid Weather Seal |
Shaunsyd wrote: I just pushed them in with a pair of long nosed pliers broke a couple but don't remember having a lot of difficulty Yes. But considering everything you've been through, this would have seemed an 'easy' job! |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|