| ausmini https://www.ausmini.com/forums/ |
|
| Remote shifter hole https://www.ausmini.com/forums/viewtopic.php?f=2&t=101629 |
Page 1 of 1 |
| Author: | TK [ Sat Dec 17, 2022 7:54 pm ] |
| Post subject: | Remote shifter hole |
Putting a remote shifter into an 850. Anyone got any measurements or even just a photo? |
|
| Author: | gtogreen1969 [ Sat Dec 17, 2022 8:44 pm ] |
| Post subject: | Re: Remote shifter hole |
56 cm to 65 cm from the passenger door sil 4 cm to 16 cm forward of crossmember I would cut it a bit smaller to start with then test and adjust as needed Attachment: 56 - 65 cm from the passenger door sil. 4 - 16 cm forward, Remote floor hole.png
|
|
| Author: | TK [ Sat Dec 17, 2022 8:57 pm ] |
| Post subject: | Re: Remote shifter hole |
Thank you so much. |
|
| Author: | andrew9 [ Sun Dec 18, 2022 8:58 pm ] |
| Post subject: | Re: Remote shifter hole |
How difficult is it to fit a remote shifter in an 850 with a RC40, while keeping the starter button? |
|
| Author: | IndigoBlueCooperS [ Sun Dec 18, 2022 10:01 pm ] |
| Post subject: | Re: Remote shifter hole |
Have the remote shifter, RC40 (1&7/8?) and 850 push button start in my Monaco which is based on a 62 850. Made sure the battery cables had the lugs on the best way to keep them away from the exhaust. No problems with it. |
|
| Author: | timmy201 [ Mon Dec 19, 2022 8:05 am ] |
| Post subject: | Re: Remote shifter hole |
I had to give the exhaust pipe a bit of a hit with the hammer to give clearance. With the exhaust tucked up a bit more it had made contact before I added the divot |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|