| ausmini https://www.ausmini.com/forums/ |
|
| Hand brake quadrants https://www.ausmini.com/forums/viewtopic.php?f=2&t=101689 |
Page 1 of 1 |
| Author: | slacko [ Tue Jan 31, 2023 9:16 pm ] |
| Post subject: | Hand brake quadrants |
which way do the hand brake quadrants go ? long end to drum or to lever ? dry suspension Mark |
|
| Author: | 1071 S [ Wed Feb 01, 2023 7:40 am ] |
| Post subject: | Re: Hand brake quadrants |
Don't remember... but its easy to get it right. If you have them upside down, the long end will hit the subframe (which prevents the handbrake being fully deployed). I know this because for many years I had issues with the handbrake on one side. Yep, one quadrant correct and the other upside down  Do a trial fit. It will be obvious which is correct. Cheers, Ian |
|
| Author: | slacko [ Wed Feb 01, 2023 10:55 pm ] |
| Post subject: | Re: Hand brake quadrants |
Put them in with long pointy end towards the drum Had to buy another set of handbrake cables as the first set are total BS Waste of $80 springs to long to even fit between the lever and the bracket , hole to small for the clevis pin locating block to quadrant 1inch different in length between the two cables from clevis pin This is the crap available to us today Rang the supplier and they said they would contact their supplier , YER RIGHT |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|