| ausmini https://www.ausmini.com/forums/ |
|
| Tapping water jacket in head+block https://www.ausmini.com/forums/viewtopic.php?f=2&t=102423 |
Page 1 of 1 |
| Author: | mattsmadmini [ Mon Oct 28, 2024 8:29 am ] |
| Post subject: | Tapping water jacket in head+block |
Finally got my 66thou Cometic gasket for the moke. 99% of the hole line up perfectly except for a water hole in head and block near the engine steady close to 4th cyl. For reference this is a big bore gasket onto a small bore engine the bk450 fit fine. What do I use to 'plug' these holes? |
|
| Author: | drmini in aust [ Mon Oct 28, 2024 3:28 pm ] |
| Post subject: | Re: Tapping water jacket in head+block |
Drill and tap for a brass plug, screw it in with loctite then deck it flush. How I did Joe's 1108 with 68mm bore. Using a 202 head and bk450 gasket. Edit After you plug and deck it you can drill the hole where wanted. PM sent. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|