I have this carby, just got it for $10 off ebay. But, I don't understand all the extra piping. Its a 1.1/2 SU, but thats as much as I know. Ideas??
| ausmini https://www.ausmini.com/forums/ |
|
| Carby Identification https://www.ausmini.com/forums/viewtopic.php?f=2&t=10731 |
Page 1 of 1 |
| Author: | rampage101 [ Fri Sep 02, 2005 3:05 pm ] |
| Post subject: | Carby Identification |
|
I have this carby, just got it for $10 off ebay. But, I don't understand all the extra piping. Its a 1.1/2 SU, but thats as much as I know. Ideas?? |
|
| Author: | J_A_M [ Fri Sep 02, 2005 3:07 pm ] |
| Post subject: | |
fuel return? |
|
| Author: | min13k [ Fri Sep 02, 2005 3:13 pm ] |
| Post subject: | |
could be from a 6 triple setup the plastick tube is were the stink pipe off the rocker cover or whatever goes to makka |
|
| Author: | rampage101 [ Fri Sep 02, 2005 3:17 pm ] |
| Post subject: | |
Umm, ok 
So, what do I do? Block some of them off? |
|
| Author: | Morris 1100 [ Fri Sep 02, 2005 7:03 pm ] |
| Post subject: | |
The two hoses to the float bowl are fuel from the pump and the vent to the charcoal cannister. The hose to the side of the carby is the vac line to the dizzy The plastic tube into the side of the carb above the float bowl is from the pcv valve. |
|
| Author: | drmini in aust [ Fri Sep 02, 2005 7:28 pm ] |
| Post subject: | |
Morris 1100 wrote: The two hoses to the float bowl are fuel from the pump and the vent to the charcoal cannister.
The hose to the side of the carby is the vac line to the dizzy The plastic tube into the side of the carb above the float bowl is from the pcv valve. Um... it's from the crankcase breather. PCV valve (into manifold)was replaced by this vac line into the SU body. It works, sort-of. Not as good as the old PCV... 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|