I didn't think you had `cold air' up in Qld..
Your idea is OK but use 3" heater ducting or similar, thet's what a lot of race cars do. But they don't attach it to the carb- just take the air up to near it (ramtube or sports filter).
| ausmini https://www.ausmini.com/forums/ |
|
| Getting Cold Air https://www.ausmini.com/forums/viewtopic.php?f=2&t=1122 |
Page 1 of 1 |
| Author: | 1380 yellow devil [ Sat Jul 10, 2004 9:45 pm ] |
| Post subject: | Getting Cold Air |
Nya ideas on ways to make a cold air induction on a Mini. I was just thinking of running a Flexi hose bout 1-2 Inches in diameter from under the front of the car up to the Air cleaner. Not to sure what eles I can do. I have heard of people making up a bent pipe that goes onto the Card (SU) and sits around in front of the Motor on the Clutch housing side. |
|
| Author: | drmini in aust [ Sat Jul 10, 2004 10:11 pm ] |
| Post subject: | |
I didn't think you had `cold air' up in Qld..
Your idea is OK but use 3" heater ducting or similar, thet's what a lot of race cars do. But they don't attach it to the carb- just take the air up to near it (ramtube or sports filter). |
|
| Author: | jill200sx [ Sat Jul 10, 2004 10:16 pm ] |
| Post subject: | |
| what a great idea! Cold air intake.. sounds impressive too
I thinks there's a section in David Vizards MTMYM on ram air intake, would prolly mean cutting a hole in the bonnet and a scoop but 
|
|
| Author: | 1380 yellow devil [ Sat Jul 10, 2004 10:34 pm ] |
| Post subject: | |
Thats the main reason why i want to do it. To try and get cooler air into that area istead of the warm air from around the engine and strags. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|