Need a favour...
Can someone close to a mini go mesure to x member in the engine bay. I need the up- down height ASAP to get this turbo box cut out..
Thanks in advance
Cody
| ausmini https://www.ausmini.com/forums/ |
|
| x member height? https://www.ausmini.com/forums/viewtopic.php?f=2&t=11408 |
Page 1 of 1 |
| Author: | GT1360 [ Wed Sep 21, 2005 9:55 am ] |
| Post subject: | x member height? |
Need a favour... Can someone close to a mini go mesure to x member in the engine bay. I need the up- down height ASAP to get this turbo box cut out..
Thanks in advance Cody |
|
| Author: | doorlady [ Wed Sep 21, 2005 10:38 am ] |
| Post subject: | |
Hi The centre of the x member is 60mm and goes wide off to the sides to 85mm Hope this helps Janelle |
|
| Author: | GT1360 [ Wed Sep 21, 2005 10:48 am ] |
| Post subject: | |
Thank you SO much...  stupid engineering drawing I had was missing that One size. 
Cody |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|