Couple of 90* steel mandrel bends, turn 2 tapered tubes on a lathe, weld together with flanges, = make yer own. Not rocket science.. I made some for twin Amal bike carbs on the Mini, once.
| ausmini https://www.ausmini.com/forums/ |
|
| Webber IDA Manifold https://www.ausmini.com/forums/viewtopic.php?f=2&t=1150 |
Page 1 of 1 |
| Author: | Bent'S [ Wed Jul 14, 2004 12:26 am ] |
| Post subject: | Webber IDA Manifold |
Does anyone know where I can find an IDA manifold foer an A series?? |
|
| Author: | ausminis4u [ Thu Jul 15, 2004 6:05 pm ] |
| Post subject: | Re: Webber IDA Manifold |
Bent 'S' wrote: Does anyone know where I can find an IDA manifold foer an A series?? u will have to get a custom one m8, i dunno if it would clear the bonnet( on a mini ) any way
|
|
| Author: | Christoph [ Thu Jul 15, 2004 9:25 pm ] |
| Post subject: | |
IDA manifolds were built at some stage, but i dont think many were made. T.W.M. in the USA manufactured them.. dont know if they still do, probably not. For an IDA to work you need some kind of cover or scoop in the bonnet because at high speed air buffeting causes loss of power. Very good carb if set up right. |
|
| Author: | drmini in aust [ Thu Jul 15, 2004 9:29 pm ] |
| Post subject: | |
Couple of 90* steel mandrel bends, turn 2 tapered tubes on a lathe, weld together with flanges, = make yer own. Not rocket science.. I made some for twin Amal bike carbs on the Mini, once.
|
|
| Author: | graham in aus [ Thu Jul 15, 2004 9:57 pm ] |
| Post subject: | |
Look out Kev, doing it on thre cheap again! COOL! lol: |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|