Hi,
What is the best way to cut the carpet at the rear to allow it to slide under the seat support (how should it be done!) You could cut a chunk out, slit it once and then again at a right angle?
| ausmini https://www.ausmini.com/forums/ |
|
| Rear carpet installation https://www.ausmini.com/forums/viewtopic.php?f=2&t=12257 |
Page 1 of 1 |
| Author: | deleted [ Mon Oct 17, 2005 7:42 pm ] |
| Post subject: | Rear carpet installation |
Hi, What is the best way to cut the carpet at the rear to allow it to slide under the seat support (how should it be done!) You could cut a chunk out, slit it once and then again at a right angle?
|
|
| Author: | NoMoreMinis [ Mon Oct 17, 2005 7:47 pm ] |
| Post subject: | |
I'd slot it in a 'T' shape.....so that it hugs that centre bit when it's all in...... Jeremy |
|
| Author: | Dylans Clubby [ Mon Oct 17, 2005 7:48 pm ] |
| Post subject: | |
i cut a hole where the post goes, nice tight fit, then make an incision below the main aorta... i mean make an incision form your fresh new hole to the back of the carpet. you may want to edge it properly or something, i didnt and its not falling apart, but i can't imagine it being a bad idea. also you will need to cut a hole for your rear seat mounts, im not sure whether the new carpets cme whit this or not though. also seat belt clips and handbrake |
|
| Author: | deleted [ Mon Oct 17, 2005 8:07 pm ] |
| Post subject: | |
rear seat mounts? what rear seat mounts?!! Thanks for replies btw, T thing soundeth good. |
|
| Author: | Dylans Clubby [ Mon Oct 17, 2005 8:29 pm ] |
| Post subject: | |
oh sorry i meant the front seat mounts (but they are at the bcak of the front seats... 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|