ausmini
https://www.ausmini.com/forums/

removing wiper's box wheels set up n motor
https://www.ausmini.com/forums/viewtopic.php?f=2&t=12432		 Page 1 of 1
Author:  lobby69 [ Sun Oct 23, 2005 4:43 pm ]
Post subject:  removing wiper's box wheels set up n motor
hey fellas, hit a progress brick wall today,

ive got the wiper motor loose from the firewall, but how do i get the wiper arm control thing from inside the engine bay at the top of the firewall???

ive got the wiper arms off, and there is a nut behind wiper (behind the bonnet infront of the widnscreen) that i tryed to undo but the entire nut and thread move together, been looking at all my leyland and morris books but none have a detailed description,

any help in this regard would be awsum....as i am lost with this one! :cry:

blake :wink:
Author:  WhoDat [ Sun Oct 23, 2005 5:08 pm ]
Post subject: 
Have a read in here

http://www.ausmini.com/forums/viewtopic.php?t=4917
Author:  lobby69 [ Sun Oct 23, 2005 5:32 pm ]
Post subject: 
so theres no trik to getting the wheel box nuts undone...... so i have to cut them off???

no other trick to get them off in one piece?

blake :wink:
Author:  WhoDat [ Sun Oct 23, 2005 5:38 pm ]
Post subject: 
Apart from Lots of WD40 and let it soak to loosen off, I can only suggest pushing the wheel box upwards from underneith so that the nut is not jamming while you turn it. you prolly have tried that alrady.

Good luck
Author:  lobby69 [ Sun Oct 23, 2005 6:16 pm ]
Post subject: 
i'll hit it with wd40 tonoght and hope she comes apart tomorow arvo,

blake :wink:
Author:  drmini in aust [ Sun Oct 23, 2005 6:45 pm ]
Post subject: 
Cut nuts carefully on 1 side with an angle grinder. You can buy new chrome nuts. 2 types- 6 sided (early) & 8 sided (late). But threads same I think.. :wink:
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/