...and the flash time between coats is 5-7 minutes, can I leave my gun for that time or will it clog up the jets? Or can I give it a little squirt every minute or so to keep it clear, or does it just not matter?
TIA
| ausmini https://www.ausmini.com/forums/ |
|
| Q: When spraying acrylic... https://www.ausmini.com/forums/viewtopic.php?f=2&t=12615 |
Page 1 of 1 |
| Author: | Angusdog [ Sat Oct 29, 2005 4:06 am ] |
| Post subject: | Q: When spraying acrylic... |
...and the flash time between coats is 5-7 minutes, can I leave my gun for that time or will it clog up the jets? Or can I give it a little squirt every minute or so to keep it clear, or does it just not matter? TIA
|
|
| Author: | Besser [ Sat Oct 29, 2005 7:20 am ] |
| Post subject: | Pends on what your spraying |
Tak time should be shorter then that. Sounds like your skimping on the thinners. Anyway.... if your doing a whole car with a 50% overlap you'll get back to the start panel in 5+ minutes so the gun wont clog. The needle will seal off the paint. Get a cloth dip it in thinners a scrub the needle tip and exit face if you get build up. The first squirt after a delay needs to be to clear away any gunk then your ok. |
|
| Author: | Angusdog [ Sat Oct 29, 2005 7:53 am ] |
| Post subject: | |
Thanks for that - all I needed to know. I'm just practicing on a boot lid at the mo, so it only take a minute to spray it. |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|