| ausmini https://www.ausmini.com/forums/ |
|
| Rover body wheel arch size - Rear Cut - and trailer Q's https://www.ausmini.com/forums/viewtopic.php?f=2&t=12711 |
Page 1 of 1 |
| Author: | Bromley [ Mon Oct 31, 2005 8:28 pm ] |
| Post subject: | Rover body wheel arch size - Rear Cut - and trailer Q's |
Are the wheel arches on a Rover mini the same size as a Morris despite the fact they run 12" wheels? Anyone able to give me an idea of what a Rover rear cut would be worth without the fuel tank and sub-frame? I have uncovered one for sale and am considering making a trailer out of it similar to another one I have seen an ausmini member with. Anyone got any suggestions about how hard such a job would be? Regards, Andy. |
|
| Author: | poeee [ Mon Oct 31, 2005 8:42 pm ] |
| Post subject: | |
A 12" Rover will have the same wheel arches as an Aussie Mini. (unless i'm VERY MUCH mistaken!) |
|
| Author: | cush [ Mon Oct 31, 2005 8:43 pm ] |
| Post subject: | |
i'd assume they are... you don't cut body work with most 12's and so the bodywork the flares attach to is the same... |
|
| Author: | Bromley [ Mon Oct 31, 2005 10:16 pm ] |
| Post subject: | |
Yea flare kits fit both, I just wanted to check. |
|
| Author: | Mick [ Tue Nov 01, 2005 7:15 am ] |
| Post subject: | |
Keep us posted with your trailer, I'd love to build one and a 'how to' would be tops. I reckon trailer electrics are nearly as dodgy as mini electrics, sos they're a good subject car to make a trailer out of. |
|
| Author: | doorlady [ Tue Nov 01, 2005 3:59 pm ] |
| Post subject: | |
Bromley Look at this web site gives you the basic idear, I did change it a little a the back and the draw bar . If you need any more info you can PM me . ADAM http://www.niksula.cs.hut.fi/~mdobruck/ ... ailer.html |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|