Not that easy - need stiffening otherwise it will bend in the middle as soon as you open the doors! And engineers cert.
Just buy a Moke
| ausmini https://www.ausmini.com/forums/ |
|
| Soft top https://www.ausmini.com/forums/viewtopic.php?f=2&t=12783 |
Page 1 of 1 |
| Author: | scotty [ Wed Nov 02, 2005 8:39 pm ] |
| Post subject: | Soft top |
I had a thought about chopping the deluxe and putting on a soft top. Is it as easy as getting out the old angle grinder, slice it up in the right places, weld on a couple of plates to clean it up, weld on a roll bar, and put on the soft top? how much are they and where can you get these tops from? |
|
| Author: | awdmoke [ Wed Nov 02, 2005 9:14 pm ] |
| Post subject: | |
Not that easy - need stiffening otherwise it will bend in the middle as soon as you open the doors! And engineers cert. Just buy a Moke
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|