ausmini
https://www.ausmini.com/forums/

Late 998 standard needle
https://www.ausmini.com/forums/viewtopic.php?f=2&t=13856		 Page 1 of 1
Author:  poeee [ Fri Dec 09, 2005 3:11 pm ]
Post subject:  Late 998 standard needle
What needle should be in a standard late 998 with 1.5" SU?
Author:  K-Bar [ Sun Dec 11, 2005 7:17 pm ]
Post subject: 
a few to chose from apparently..lol

AAA
AAU
ABY-richer high end
Author:  Volodkovich [ Sun Dec 11, 2005 8:11 pm ]
Post subject: 
ADE is the correct needle for a late 998.

AAA is wayy too rich, i dont know where you got those needles from K-Bar?
Author:  NAV [ Sun Dec 11, 2005 10:39 pm ]
Post subject: 
The needle in nav was an ABX before it got customised to suit the extractors and 1"3/4 exhaust
Author:  K-Bar [ Mon Dec 12, 2005 11:56 am ]
Post subject: 
a program we all probably know.

WINSU.
Author:  K-Bar [ Mon Dec 12, 2005 3:41 pm ]
Post subject: 
yeh i have and ABX at the moment...but now i have the extractors and rc40.. free flow air filter...what should i use now NAV?? or wat should i do to the ABX

cheers
Author:  NAV [ Mon Dec 12, 2005 4:40 pm ]
Post subject: 
K-Bar wrote:
yeh i have and ABX at the moment...but now i have the extractors and rc40.. free flow air filter...what should i use now NAV?? or wat should i do to the ABX

cheers


My needle was customised to make it richer in the top end.

Win su reccomends AAA / AAU or ABY. Just about any needle that is richer in the top end will work better than your stocko. If you set the mix at idle you will get a lean top end and vice versa

They modified mine to get me to a dyno. I haven't been to a dyno yet. :oops: :roll:
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/