ausmini
https://www.ausmini.com/forums/

8.8mm Top Gun leads
https://www.ausmini.com/forums/viewtopic.php?f=2&t=145		 Page 1 of 1
Author:  J_A_M [ Fri Mar 26, 2004 1:48 pm ]
Post subject:  8.8mm Top Gun leads
What are they worth?
Author:  boost_morrre [ Fri Mar 26, 2004 3:46 pm ]
Post subject: 
do a search on ebay, i think someone has some fs starting at $1 or $20 brand new...prob stil there cause i saw it about 2 days ago
Author:  J_A_M [ Fri Mar 26, 2004 8:15 pm ]
Post subject: 
Yea I know. I put a bid on them before I started this thread. After bidding I thought......maybe I bid too much, so I am now asking what they would normally be worth!
Author:  MiniK [ Fri Mar 26, 2004 9:44 pm ]
Post subject: 
i think they are about 30 bucks a pair or thereabouts......
Author:  PhildoD [ Fri Mar 26, 2004 10:24 pm ]
Post subject: 
ummmmm, top gun leads, last time I checked was about 50 bucks a set of four or six, cant remember, check your closest Auto-one shop.

I used to use 10.0 mm leads on my old car. no drama's ever with em, cept for the fact the stereo had some funny buzz goin through it all the time. :? :? :? :?
Author:  boost_morrre [ Sat Mar 27, 2004 1:11 am ]
Post subject: 
Just shop around or call a few places.
Author:  998_Clubman [ Sat Mar 27, 2004 10:20 am ]
Post subject: 
i went through 2 sets during last week at work.. now these figures are in trade price..

the first car was a vs x 6 leads they were $40.. maybe about $70ish retail..
2nd was a 3y motor hilux ute x 4 , and they were around $20 trade.. so yeah, bout 40-50
Author:  drmini in aust [ Sat Mar 27, 2004 3:53 pm ]
Post subject: 
Bosch `Super Sports Inductive Core' leads are good enough for many race Minis and they are just $5 each at Supercheap.. 8)

I used to use Top Guns but found they were only good for a couple of years, then the resistance goes up... :cry:
Author:  min13k [ Sat Mar 27, 2004 8:06 pm ]
Post subject: 
hey kevin did you ever make the good ol copper leads my old man made a set fer a rotor i had :twisted:
makka
Author:  drmini in aust [ Sun Mar 28, 2004 6:32 am ]
Post subject: 
Older Minis were made with copper leads and suppression caps. :wink:
Strange as it may seem, you do get a stronger spark with some resistance in the HT circuit. If you are using copper leads, either fit 6-10Kohm suppressor caps, or use resistor plugs eg `BPR6ES'.

Don't use `R' type plugs with suppression cables- these already have 5-8Kohm resistance when new. 8)
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/