ausmini
https://www.ausmini.com/forums/

The new donk is in!!!
https://www.ausmini.com/forums/viewtopic.php?f=2&t=14820		 Page 1 of 1
Author:  scotty [ Tue Jan 10, 2006 9:47 pm ]
Post subject:  The new donk is in!!!
Well I'm excited now. Since Friday afternoon we have been working on the beast. After a couple of hours prep on Friday arvo, about 13 hours on Saturday, 10 on Sunday and an hour or so fine tuning today, the 1100 has been ripped out and a stonker of a 1380 has been put in! :D
Specs are:
1100 'S' block bored 40thou
Semi-flat-top pistons (?)
Stroker crank
Cooper S cam ground to an RE13
Ported AEG316 head
40mm Dellorto DHLA
4 syncro box freshly rebuilt
There was more.....but can't remember.

Has been very hard work but it has paid off. Was intertesting driving it home today when I gave it a bit the whole cabin filled with smoke :shock: Lucky it was only because of the breather being drilled in the wrong spot - quickly fixed when we got back! :lol:

Big thanks goes out to:
Ben Tebutt for building the engine, all the advice, hard work and patience
Michael Glendenning (minimic) for all his hard work.
Chris.....Didn't know his last name - only met him on Saturday. He had a heap of knowledge and put in the hard yards.
Steve "Beave". for helping with the fine tuning today.

I should really go to bed now..........but I can never sleep.
Author:  willy [ Tue Jan 10, 2006 9:51 pm ]
Post subject: 
Sounds very nice.
I bet it goes hard :D
Author:  Namibian CAMEL [ Tue Jan 10, 2006 9:56 pm ]
Post subject: 
willy wrote:
Sounds very nice.
I bet it goes hard :D

Which he wont know because of the nice running in he must do :wink: :P

oooohhhhhh
sounds so nice :P

make sure you be nice to it :)
Author:  Gerard [ Tue Jan 10, 2006 9:59 pm ]
Post subject: 
Congrats Scotty
I am in the same boat - 1310 to go in may be this weekend
Cheers Gerard
Author:  gafmo [ Tue Jan 10, 2006 10:01 pm ]
Post subject: 
Comming from you Camel that is Priceless

Well done Guys :wink:
Author:  Klubman [ Tue Jan 10, 2006 10:08 pm ]
Post subject: 
Yes Camel
How long before you are runninig in.
Nigel
Author:  9YaTaH [ Tue Jan 10, 2006 10:13 pm ]
Post subject:  Re: The new donk is in!!!
scotty wrote:
Ben Tebutt for building the engine, all the advice, hard work and patience\


Rest assured....solid donk :D
Author:  scotty [ Tue Jan 10, 2006 10:18 pm ]
Post subject:  Re: The new donk is in!!!
9YaTaH wrote:
scotty wrote:
Ben Tebutt for building the engine, all the advice, hard work and patience\


Rest assured....solid donk :D


Should be. The block used is the one he set the lap record at Eastern Creek! :D
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/