Hey we're thinking about fitting a retro dash to the Clubby van. Partly because there's SFA in it now, and I have a Mk2 binnacle complete ready to go.
There used to be a wiring loom available for this, it plugged into the Clubby one and had all the flying leads for the speedo's warning lamps etc.
Anybody seen one lately? I searched MS and MM sites, drew a blank.

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R.

Kev it may be easier to put the roundie wiring in, dont think you will have to modifie to much that way do you?

_________________
1974 Moke - 998cc
76 Clubman B16a2 Vtec AWD Turbo 12.9@105mph
https://www.youtube.com/watch?v=V9PW49e1hYs

Is this what you are looking for?

http://www.minispares.com/SearchResults ... od=0&ty=fi[/url]

pm aussie. his (wet) clubman has the centre binnacle setup in it, he may sell you the loom. cheers, ben .

_________________
lookin for another clubby

Yeah that one would do. I could just cut the plug off the Clubby loom, saving 1" of wire on the plug, in case...
There was another version of this one with a socket on, the Clubby loom just plugged into it.

_________________
DrMini- 1970 wasaMatic 1360, Mk1S crank, 86.6HP (ATW) =~125 @ crank, 45 Dellorto (38 chokes), RE282 sprint cam, 1.5 rockers, 11.0:1 C/R.