| ausmini https://www.ausmini.com/forums/ |
|
| Conversion wiring loom, Clubby to centre binnacle https://www.ausmini.com/forums/viewtopic.php?f=2&t=16096 |
Page 1 of 1 |
| Author: | drmini in aust [ Sun Feb 12, 2006 7:49 am ] |
| Post subject: | Conversion wiring loom, Clubby to centre binnacle |
Hey we're thinking about fitting a retro dash to the Clubby van. Partly because there's SFA in it now, and I have a Mk2 binnacle complete ready to go. There used to be a wiring loom available for this, it plugged into the Clubby one and had all the flying leads for the speedo's warning lamps etc. Anybody seen one lately? I searched MS and MM sites, drew a blank. 
|
|
| Author: | 13secmini [ Sun Feb 12, 2006 7:59 am ] |
| Post subject: | |
Kev it may be easier to put the roundie wiring in, dont think you will have to modifie to much that way do you? |
|
| Author: | Mini68 [ Sun Feb 12, 2006 8:09 am ] |
| Post subject: | |
Is this what you are looking for? http://www.minispares.com/SearchResults ... od=0&ty=fi[/url] |
|
| Author: | ausminis4u [ Sun Feb 12, 2006 12:33 pm ] |
| Post subject: | |
pm aussie. his (wet) clubman has the centre binnacle setup in it, he may sell you the loom. cheers, ben . |
|
| Author: | drmini in aust [ Sun Feb 12, 2006 1:44 pm ] |
| Post subject: | |
Mini68 wrote:
Yeah that one would do. I could just cut the plug off the Clubby loom, saving 1" of wire on the plug, in case... 
There was another version of this one with a socket on, the Clubby loom just plugged into it. 
|
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|