ausmini
https://www.ausmini.com/forums/

Ignition Leads....
https://www.ausmini.com/forums/viewtopic.php?f=2&t=16448		 Page 1 of 1
Author:  pulver [ Mon Feb 20, 2006 7:48 pm ]
Post subject:  Ignition Leads....
G'day everyone,

Sorry if this sounds like a silly question. But are all ignition leads interchangeable?
I have a Nissan pulsar dizzy but i am still using my old leads cause the nissan ones are dodgy. When I buy a new set do I buy mini leads or nissan leads?

Thanks
Author:  1380 yellow devil [ Mon Feb 20, 2006 8:04 pm ]
Post subject: 
Well i have fitted Mini ones. They were made by Queensland Ignition Leads and are the Sprial type. You will be able to fit the mini ones. They will look neater as they will be a lot shorter.
Author:  awdmoke [ Mon Feb 20, 2006 8:09 pm ]
Post subject: 
TopGun all right angled leads fit beaut- part # TG4010B
Just got some yesterday, and I'm running a pulsar dizzy on the Countryman.

Coil lead doesn't reach the firewall though :(
Author:  pulver [ Mon Feb 20, 2006 8:15 pm ]
Post subject: 
sweet....cause those nissan ones a way to long.

Thanks fellas
Author:  Mick [ Mon Feb 20, 2006 8:43 pm ]
Post subject: 
No real difference in leads, but I did have a guy try to convince me once that I had to buy specific Subaru ignition leads for my old sooby.
I asked him what kind of spark subaru used for their 240 dollar leads. He said he didn't know but it was special. :roll:
Author:  drmini in aust [ Mon Feb 20, 2006 8:57 pm ]
Post subject: 
I used to use Top Guns but found they broke down in wet weather after a couple of years.
I changed to Bosch ones, @ $5 each (in various lengths, from yer local Supercrap store) years ago, no more problems.:)
Author:  pulver [ Mon Feb 20, 2006 9:05 pm ]
Post subject: 
Cool, I'll have to take them in and match them up soon. I got zapped by one the other day which was a shock cause the insulation around the plugs looks fine....
Page 1 of 1 All times are UTC + 10 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/