| ausmini https://www.ausmini.com/forums/ |
|
| sanding paper ? https://www.ausmini.com/forums/viewtopic.php?f=2&t=18506 |
Page 1 of 1 |
| Author: | _666_ [ Tue Apr 25, 2006 6:06 pm ] |
| Post subject: | sanding paper ? |
ok im a novice.. and need to finish sanding my car.. 250 grade wet ?.. or wat ? |
|
| Author: | Blokeinamoke [ Tue Apr 25, 2006 6:12 pm ] |
| Post subject: | |
Are you sanding finish coat? 320, then 400, then 1200 |
|
| Author: | _666_ [ Tue Apr 25, 2006 6:16 pm ] |
| Post subject: | |
sanding to bare metal... its alread halfway there on the outside... |
|
| Author: | Blokeinamoke [ Tue Apr 25, 2006 6:24 pm ] |
| Post subject: | |
I never use sandpaper to take a shell back to metal. I use a wirebrush on an angle grinder. It leaves less marks on the surface. $25 for the wire brush fitting, $20 for angle grinder. A cheapy from Kmart is fine for the grinder. When its breaks, they swap it for a new one. |
|
| Author: | JAM_IT [ Tue Apr 25, 2006 7:10 pm ] |
| Post subject: | |
IMHO I wouldn't bother asking those type of questions here. If you are REALLY serious about knowing the answer(s), ask the questions here: http://autobody101.com/forums/index.php and do yourself a favor and download this: http://autobody101.com/download.php That is the freakin BIBLE for body work! |
|
| Author: | _666_ [ Wed Apr 26, 2006 12:29 am ] |
| Post subject: | |
rotissery guide is kewl... but the shel prep doesnt really mention anything bout sanding paper grades and sugestions... |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|