| ausmini https://www.ausmini.com/forums/ |
|
| Smiths gauges https://www.ausmini.com/forums/viewtopic.php?f=2&t=196 |
Page 1 of 1 |
| Author: | Mike [ Thu Apr 01, 2004 3:53 am ] |
| Post subject: | Smiths gauges |
Another question - where can I get the light bulbs and bulb holders for smiths gauges? are there generic equivalents in Jaycar etc? If i'm putting a different (used) rev counter does it have to be calibrated etc? Cheers. |
|
| Author: | drmini in aust [ Thu Apr 01, 2004 6:47 am ] |
| Post subject: | |
Best place to get gauge bulb holders is at a wrecker- these were common in many British cars. Some servos have the bulbs in stock still. As long as the tacho is out of a 4cylinder car it will be OK. I use a 9,000 rpm one from a Fiat 124BC coupe. It has much better needle damping than all the Smiths ones.. 
|
|
| Author: | Mike [ Fri Apr 02, 2004 2:32 pm ] |
| Post subject: | |
Ok I'll try the wreckers and might also try to find something similar at Jaycar. Thanks., |
|
| Author: | min13k [ Fri Apr 02, 2004 6:18 pm ] |
| Post subject: | |
on canterbury rd just past the turn of for marricville that do jags i would imagine that they have the stuff you need makka |
|
| Page 1 of 1 | All times are UTC + 10 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|